Advertisement
4.1
Attaching the Display Adapter Brackets
To attach the extension adapters, align the adapter bracket holes with those on the TV-facing side of the adapter plate
and secure in place with the included bolts (O). The display adapter brackets can reach VESA patterns up to 400×400
and provide additional flexibility when needed. Reference the examples below for some ways the adapter brackets
can be used to achieve various VESA patterns.
Warning: Over-tightening can damage the bolts or the display and is not covered under warranty. Make sure the
fasteners are tight enough not to rattle loose while the mount is in use.
400×400
4.2
Attaching the Display
• Carefully lay the display face-down on a soft surface.
• Locate the four mounting holes in the back of the display housing. Carefully test threading the screws (C through G)
into the back of the display until you find the proper thread.
• Lay the adapter plate centered over the display with the two roll adjustment screws toward the bottom of the display.
Ensure the mounting holes of the display match up properly to four of the holes in the adapter plate.
• Check the clearance between the TV and the plate. If the plate won't sit flat against the back of the television, place
spacers (H through K) and washers (L or M) between the display and the plate as needed.
• Fasten the plate to the display. Use screws long enough to thread securely into the display without bottoming out.
Warning: Over-tightening can damage the bolts or the display and is not covered under warranty. Make sure the
fasteners are tight enough not to rattle loose while the mount is in use.
5.
Attach the Display to the Arm Asembly
• Lift the display and place the bolt at the center of
the plate into the notch as shown. Once placed,
the two bolts at the bottom will swing into place
through the level adjustment slots.
• Secure the display using the two Nylon washers
(R), two metal washers (Q), and lock nuts (P).
Be sure to place the Nylon washer between the
mount and the metal washer. This will allow for
easier tilt adjustments later.
• Secure the nuts with the 10mm socket wrench.
Pg. 6
400×200
400×100
R Q P
Advertisement
