Product Description And Intended Use; Safety Instructions - FIAM. SIGMY 818/T/N/X/B Product Information

SIGMY Low Table
EN
Art. 818/T/N/X/B - 819/T/N/X/B
Read this information carefully before using the product and keep it for
future reference. Failure to comply carefully with the instructions which
follow may put the safety of the product and its users at risk.

Product description and intended use

1
• Product description and composition
The SIGMY Low Table - Art. Code 818/T/N/X/B - 819/T/N/X/B is a Low Table intended as an item of indoor furniture. It is
manufactured from curved float plate glass. The SIGMY Low Table was produced at the FIAM ITALIA SPA factory at Via Ancona
1/B, 61010 Tavullia (PU), Italy - Tel: +39.0721.20051 - Fax: +39.0721.202432 - www.fiamitalia.it
• Intended use
The article known as SIGMY is designed and built to serve as a Low Table for indoor use and must therefore be used only for this
purpose and no other.
For more information about the product's intended use please refer to section "2) SAFETY INSTRUCTIONS".

Safety instructions

2
To ensure that our product is used in the conditions of the utmost safety, we urge you to comply with the safety instructions
provided below. If in doubt or if you require further information concerning the use of the product, please contact us on the
telephone numbers stated in this document.
• Transporting and storing the SIGMY Low Table in the original packaging
The SIGMY Low Table, in its original packaging, must be transported taking the greatest care to prevent knocks and shaking. It
must be stored indoors in a dry place.
Place the SIGMY Low Table in the original packaging, in the vertical position. The arrows on the label on the packaging must be
vertical and pointing upward.
Never place weights or loads in excess of 30 Kg on the original packaging, since exceeding this weight may cause the breakage
of the article.
The SIGMY Low Table in the original packaging weighs about 30 kg.
It must therefore be placed on surfaces capable of supporting its weight.
• Removing the packaging - assembly
To remove the original packaging of the SIGMY Low Table, proceed as follows.
a) Place the packaging crate vertical. The arrows on the labels on the outside must be vertical and pointing upward.
b) Open the packaging crate and remove the sheets of polystyrene. Do not use hammers, saws, cutters or other tools which may
damage the SIGMY Low Table.
c) Remove the SIGMY Low Table from its packaging. Wear gloves which assure a good grip on the float glass.