kingsley-bate CO-30SR Assembly Instructions

ASSEMBLY INSTRUCTIONS FOR THE CO-30SR

RIGHT END FRAME

SEAT FRAME

STEP-I

Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.

NOTE: During assembly of the furniture please match joints with the corresponding letters or

numbers stamped on the wood. Do not remove cardboard rolls from bottom of BASE until

fully assembled.

BACK

SEAT INSERT

Gently lay the END FRAME with the stamps near the

mortise holes on a clean, flat surface and fit the BACK,

and the SEAT FRAME tenons into the END FRAME

mortise holes. If necessary, gently rock the parts while

pushing down on them until all the joints fit snugly

together.

LEFT END FRAME

BASE

Table of Contents

Do you have a question about the CO-30SR and is the answer not in the manual?

Page 1 ASSEMBLY INSTRUCTIONS FOR THE CO-30SR RIGHT END FRAME BACK LEFT END FRAME SEAT FRAME SEAT INSERT BASE STEP-I Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood. NOTE: During assembly of the furniture please match joints with the corresponding letters or numbers stamped on the wood.
Page 2 KINGSLEY BATE FURNITURE, PLEASE CONTACT THE KINGSLEY BATE DEALER NEAREST TO YOU OR KINGSLEY BATE DIRECTLY. WE THANK YOU FOR CHOOSING OUR FURNITURE. * KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY 7200 Gateway Court, Manassas, Virginia 20109...