Smeg DCF02 Instruction Manual page 12

Autostart function activation
• Press button (20)
(20)
will light up and the hours and
minutes of the set start time for brewing
the coffee will flash for a few seconds on
the display. Then the current time will be
displayed.
You can also select the intensity
(Aroma button) and the 4-cup
function when using the Autostart
function. Press the relative buttons
to memorize the functions.
• The appliance remains in AUTOSTART
mode until the pre-set time is reached.
Coffee will be brewed automatically.
• Press button (20)
from this mode.
Machine settings
The appliance allows you to personalise
some settings:
• clock settings
• time format
• water hardness
• activation / deactivation of the acoustic
signals
Setting the clock
The time has to be set when you use the
appliance for the first time:
• Plug the appliance into an electrical
outlet.
• The symbols on the display flash.
• Set the time by moving the lever up (+)
to increase the value or down (-) to
decrease it. Move the lever to the central
position and press (OK) to confirm.
8 8
: the LED of button
at any time to exit
Use
• Set by following the same procedure.
• After confirming the minutes setting, the
appliance activates the CLOCK mode.
When the appliance is switched
on for the first time, the default
time will be shown in the 12 h
time format, indicating AM/PM.
To change the time format, see
the "Time format settings menu"
section.
Time format settings menu
The time format can be set to display the
time in a 12 h or an AM/PM format.
• Access the settings menu by pressing and
holding buttons (18)
the same time for 3 seconds. Select SE01
by moving the lever and pressing it to the
"OK" position.
• Move the lever to select the required
format (12 h or 24 h)
• Move the lever to the central position
and press (OK) to confirm the setting. The
format will flash for 2 seconds: the setting
is saved.
The time format only needs to be
set once and the setting is saved.
and (19)
at