Advertisement
Quick Links
Item Numbers
610150-XX
610151-XX
610152-XX
610153-XX
610154-XX
610155-XX
Quick Start Guide
Thank you for using the ProSwap
Logger for your water monitoring!
This document will assist in the initial
steps required to set up and use the
ProSwap Logger.
The ProSwap Logger is a single port
sonde with built-in temperature and
depth sensors, and it is designed for
use with any single ProDSS digital
smart sensor.
NOTE: Turbidity and Total Algae
sensors must be used with the
Extended Probe Guard
(sold separately).
Refer to the ProSwap Logger
User Manual for:
• Part numbers and accessories
• Maintenance guidelines
• Sensor calibration instructions
• Connecting ProSwap Logger to
a data logger
1
Item #610174
[626740]
Advertisement
Related Manuals for Xylem YSI Pro Swap Logger
Summary of Contents for Xylem YSI Pro Swap Logger
- Page 1 Quick Start Guide Item #610174 Thank you for using the ProSwap Logger for your water monitoring! This document will assist in the initial steps required to set up and use the ProSwap Logger. The ProSwap Logger is a single port sonde with built-in temperature and depth sensors, and it is designed for use with any single ProDSS digital...
- Page 2 Unpacking and Inspection Inspect the outside of the shipping container(s) for damage. If you see any damage, contact the shipping carrier immediately. Carefully remove the equipment from the shipping box and verify that all contents are present. Contents • ProSwap Logger with Integrated Cable •...
- Page 3 Sensor Installation The ProSwap Logger includes built-in temperature and depth sensors in addition to a single port. The port will allow any ProDSS smart sensor to be connected. Remove the port cover shipped with the cable. Apply a thin coat of lubricant to the sensor o-rings. Carefully align the sensor and bulkhead connectors by inserting the sensor into the port then gently rotating the sensor until the connectors align.
- Page 4 Connection to Kor Software via USB Adapter or Handheld The ProSwap Logger can be connected to a PC running Kor Software via a USB adapter. A ProDIGITAL USB adapter is sold separately. Additionally, the software communication may be established through the handheld’s USB port. Install Kor Software from the included USB Drive or download the latest version from YSI.com.