Working - Sirius Satellite Radio FSED Installation, Use And Maintenance Instruction

Top air out-let (filtering version):
Remove the upper extraction outlet enclosure
cap, install the rectangular flange and any
union for the circular tube and then connect
the air outlet flange of the appliance to the
outside of the kitchen wall unit.
Activated charcoal filters are also needed,
along with metal grease filters, in the filtering
version; see the 'Maintenance' chapter.

WORKING

(Standard function instructions for the re-
mote control)
Radio remote control (combinations 4096) or
the remote control of cooker hoods.
Technical data:
- Alkaline battery powered: 12v mod. 23A
- Operating frequency: 433.92 Mhz
- Max. consumption: 25mA
- Operating temperature: -20° : +55°C
Working description:
- To light the cooker hood on or to light it off
press the button:
- To increase the speed up to the fourth one
press the button:
- To reduce the speed up to the second one
press the button:
- To go from a high speed back to the first
one press twice the button:
- To give power to the lights or to shut them
down press the button:
To set the timer up press the button:
WORKING
The LED on the right side will start to flash
(every 5 seconds), the hood will work for 10
(Standard function instructions for the re-
minutes at the selected speed and then it
RC001
mote control)
lights automatically off.
R C
ADIO
ONTROL
If the client increases or reduces the speed
Radio remote control (combinations 4096) or
Radio control used for the remote operation
while the timer is on, this is automatically
the remote control of cooker hoods.
of ducted cooker hoods.
stopped.
If the hood doesn't work properly when
Technical data:
TECHNICAL DATA
opening or closing the extractable unit, push
- Alkaline battery powered: 12v mod. 23A
- Alkaline battery powered: 12 V mod. 23 A
"TIMER" key six times consecutively in order
- Operating frequency: 433.92 Mhz
- Operating frequency: 433.92 Mhz
to reset perameters.
- Max. consumption: 25mA
- Combinations: 32.768
- Operating temperature: -20° : +55°C
- Max. consumption: 25 mA
Standard configuration :
- Operating temperature: -20 ÷ + 55 °C
If two cookerhoods-radiocontrol system are
- Dimensions: 120 x 45 x 15 mm.
installed in the same room or in the imme-
Working description:
diate vicinity, each system may affect the
- To light the cooker hood on or to light it off
OPERATING DESCRIPTION
operation of the other, due to the fact that
press the button:
The transmitter is equipped with 5 buttons
they have the same code. Therefore it will be
for cooker hood management, as specified
necessary to change the code of one of the
below:
radio controls.
- To increase the speed up to the fourth one
: Light ON/OFF command.
Warning: The battery should be replaced every
press the button:
yearto guarantee the optimal range of the trans-
: Motor ON (speed level 1) / OFF command.
mitter. To replace the exhausted battery, take
: Reduce speed.
the plastic lid off, remove the battery and re-
: Increase speed.
place it with a new one, observing the correct
- To reduce the speed up to the second one
battery polarities. Used batteries should be dis-
: 10-minute timer.
press the button:
carded in special collection bins.
INITIAL OPERATING CONDITION
Emergency switch: In the event of failure
The manufacturer supplies the radio control
of the remote control, press the emergency
- To go from a high speed back to the first unit ready to be used with codes preset in the
switch placed in the top side of the cooker
one press twice the button: Factory
hood to turn the appliance off. (fig. 15).
If you want to create a new set of codes,
proceed as follows: press and hold the UP,
STOP and DOWN buttons simultaneously for
- To give power to the lights or to shut them
2 seconds. Afterthe LEDS light up, press the
down press the button:
UP and DOWN button swithin 5 seconds. The
LEDS will flash 3 times to indicate that the
process is completed.
Warning: This procedure deletes all previously
OPERATION MODE
stored codes.
Standard configuration:
Standard configuration requires all "cooker
Learning the new transmission code:
hoods – radio control - system" to be pro-
After changing the transmission code on the
vided with the same transmission code. In
radio control, the cooker hood electronic
the event two cooker hoods – radio control
control unit must be made to set the new
system are installed in the same room or ne-
code as follows: press the main Power Off
arby, each system may affect the operation of
button on the cookerhood and then restore
the another. Therefore, the code of one radio
power to the electronic control unit. Within
control system must be changed.
the next 15 seconds, press the Light button
This will ensure the control unit is syn-
chronized with the new code.
13
12
whi
sto
If t
ope
"TIM
to r
Sta
If t
inst
diat
ope
the
nec
rad
War
yea
mit
the
plac
batt
card
Em
of t
swi
hoo
If y
pro
STO
2 s
UP
LED
pro
War
stor
Lea
Afte
rad
con
cod
but
pow
the
chr
12