Table of Contents
Advertisement
Operating and Maintenance Instructions
Terminal Block Use
The terminal blocks fitted are operated as follows:
Insert a 2.5mm or 3mm flat blade screwdriver fully into the upper hole as shown, to open the terminal wire entry.
Insert the wire into the lower hole then remove the screwdriver to leave the wire clamped in the terminal.
Alternatively, open the wire entry by inserting the screwdriver fully from the opposite side of the connector as
shown
Insert the wire into the lower hole then remove the screwdriver to leave the wire clamped in the terminal.
210-OMI13277_Iss1.doc
© ebm-papst UK Ltd, 2012
Check wire clamp has moved clear to
allow wire entry
ORIGINAL INSTRUCTIONS
Chelmsford Business Park Chelmsford Essex CM2 5EZ
Telephone: +44(0)1245468555 Fax: +44(0)1245466336
e-mail
sales@uk.ebmpapst.com
Page 13 of 15
CN1090
Advertisement
Table of Contents
