Advertisement
Quick Links
Specifications
•
Tweeter: 1" Silk Dome ±3dB Tuning
•
Woofer: 6.5" Kevlar Cone Rubber Surround ±3dB Tuning
•
Impedance: 8Ω
•
Sensitivity: 86 ±3dB
•
Frequency Range: 45Hz~20KHz
•
Power Handling RMS: 100W
•
Cut Out Dimensions: 13" x 8" (330mm x 202mm)
•
Magnetic Grill Cover
•
2 Piece Frame Design Installation
5-YEAR LIMITED WARRANTY
Rave Technology products are warranted to be free from
defects in workmanship and materials for a period of Five
(5) years from the date of purchase without charge for parts
or labor. This warranty does not apply to units that have
been subject to misuse, abuse, neglect or improper
installation, and does not apply to repairs or alterations
made by unauthorized professional. This warranty
specifically excludes responsibility for consequential damage.
Retention of your original bill of sale is required to obtain
service under the terms of this warranty.
© 2020 Rave Technology. All rights reserved.
All trademarks are the property of their respective owners.
Specifications are subject to change without notice.
Rave Technology
4100 East Baldwin Road Holly,
Michigan, 48442 USA
Tel: 866-303-2629
contact@ravetechnology.com
WWW.RAVETECHNOLOGY.COM
RK2IW-650P
In-Wall Speaker
WWW.RAVETECHNOLOGY.COM
Advertisement
Related Manuals for Rave RK2IW-650P
Summary of Contents for Rave RK2IW-650P
- Page 1 • 2 Piece Frame Design Installation 5-YEAR LIMITED WARRANTY Rave Technology products are warranted to be free from defects in workmanship and materials for a period of Five (5) years from the date of purchase without charge for parts or labor. This warranty does not apply to units that have...
- Page 2 (under an for seated listener. overhang) and to remove them in the winter. • Rave RK Series speakers require a run-in period before they deliver their best performance. They must get adapted to the temperature and Speakers spacing...
- Page 3 Wire Gauge and Quality The total wire resistance should be less than 10% of the speaker impedance. If using an 8 ohm speaker, your total wire resistance should be no more than 8 ohms. In simple terms, the extra resistance from the wire will have a very negative effect on the sound quality of the speaker.