Rave RK2IC-650P Quick Start Manual

Ceiling speaker

Download this manual

Specifications

• Tweeter: 1" Swivel Silk Dome ±3dB Tuning

• Woofer: 6.5" Kevlar Cone Rubber Surround

• Impedance: 8Ω

• Sensitivity: 86 ±3dB

• Power Handing RMS: 100W

• Frequency Range: 45Hz~20KHz

• Cut Out Diameter: 8" (206mm)

• Magnetic grill cover

• 2 Piece Frame Design

5-YEAR LIMITED WARRANTY

Rave Technology products are warranted to be free from

defects in workmanship and materials for a period of five (5)

years from the date of purchase without charge for parts or

labor. This warranty does not apply to units that have been

subject to misuse, abuse, neglect or improper installation, and

does not apply to repairs or alterations made by unauthorized

professional. This warranty specifically excludes responsibility

for consequential damage. Retention of your original bill of

sale is required to obtain service under the terms of this

trademarks are the property of their respective owners.

Specifications are subject to change without notice.

Rave Technology

4100 East Baldwin Road Holly,

Michigan, 48442 USA

Tel: 866-303-2629

contact@ravetechnology.com

WWW.RAVETECHNOLOGY.COM

Ceiling Speaker

RK2IC-650P

WWW.RAVETECHNOLOGY.COM

Need help?

Do you have a question about the RK2IC-650P and is the answer not in the manual?

Page 1 • Magnetic grill cover • 2 Piece Frame Design 5-YEAR LIMITED WARRANTY Rave Technology products are warranted to be free from defects in workmanship and materials for a period of five (5) years from the date of purchase without charge for parts or labor.
Page 2 (under an for seated listener. overhang) and to remove them in the winter. • Rave RK Series speakers require a run-in period before they deliver their best performance. They must get acclaemate to the temperature and Speakers spacing...
Page 3 Wire Gauge and Quality The total wire resistance should be less than 10% of the speaker impedance. If using an 8 ohm speaker, your total wire resistance should be no more than 8 ohms. In simple terms, the extra resistance from the wire will have a very negative effect on the sound quality of the speaker.