Problem
Only snow and noise appear on
the screen.
Dotted lines or stripes.
No color/Dark picture/Color is
not correct.
The picture is too bright.
Noisy picture.
No sound/Noisy sound
Good picture, no sound.
Audio noise.
Striped noise during
playback/recording of a VCR.
Cannot operate settings item.
Wide Screen Mode changes
automatically.
Remote control does not operate.
Possible Remedies
❑
Check if the antenna is not broken or bent.
❑
Check if the antenna has not reached the end of its serviceable life. (3-5
years in normal use, 1-2 years at the seaside.)
❑
Keep the TV away from noise sources such as cars, motorcycles, or hair-
dryers.
❑
Press PICTURE to select the desired Picture mode (page 33).
❑
Adjust the Picture Mode options in the Video settings (page 48).
❑
Press PICTURE to select the desired Picture mode (page 33).
❑
Make sure that the antenna is connected using the supplied 75-ohm coaxial
cable.
❑
Keep the antenna cable away from other connecting cords.
❑
Do not use 300-ohm twin lead cables as interference may occur.
❑
Check the volume control.
❑
Press MUTING or VOL + so that "Muting" disappears from the screen
(page 32).
❑
Disconnect your headphones.
❑
Set Speaker to On in the Audio settings (page 50). If it is set to Off, sound
is not output from the TV's speakers regardless of the TV's volume control.
❑
Make sure that the antenna is connected using the supplied 75-ohm coaxial
cable.
❑
Keep the antenna cable away from other connecting cords.
❑
Do not use 300-ohm twin lead cables as interference may occur.
❑
Press MTS/SAP to select Mono (page 33).
❑
This is caused by video head interference. Keep your VCR away from the
TV.
❑
Leave a space of 30 cm (11 7/8 inches) between your VCR and the TV to
avoid noise.
❑
Avoid installing your VCR in front of the TV or at the side of the TV.
❑
If the option you want to select appears in a pale color, you cannot select it.
❑
The current Wide Screen Mode setting is automatically replaced with the
4:3 Default setting when you change the channel or video input, if 4:3
Default in the Screen settings is set to other than Off. If you want to lock in
the Wide Screen Mode selected with the WIDE button, set 4:3 Default to
Off in the Screen settings (page 51).
❑
The batteries could be weak. Replace the batteries.
❑
Check the polarity of the batteries.
❑
Press the TV (FUNCTION) button first for TV operation.
❑
Point the remote control at the remote control sensor of the TV.
❑
Install the TV away from fluorescent lights.
❑
Press FUNCTION button for corresponding device you want to control.
Other Information
(Continued)
63