Advertisement
PRIOR TO USE
1. Clean your refrigerator thoroughly and wipe off all dust that
accumulated during shipping.
2. Install accessories such as ice cube bin, drawers, shelves,
etc., in their proper places. They are packed together to
prevent possible damage during shipment.
3. Allow your refrigerator to run for at least two to three
in the freezer compartment to ensure proper cooling. Your
refrigerator is now ready for use.
INSTALLATION
The refrigerator should always be plugged into its own
individual properly grounded electrical outlet rated for 115
Volts, 60 Hz, AC only, and fused at 15 or 20 amperes. This
provides the best performance and also prevents overloading
overheated wires. It is recommended that a separate circuit
serving only this appliance be provided.
WARNING
To reduce the risk of electric shock, do not install the
refrigerator in a wet or damp area.
REFRIGERATOR INSTALLATION
INSTALLATION (continued)
1. To avoid noise and vibration, the unit must be leveled and
the leveling legs to compensate for unevenness of the
aid in door closing. Leveling legs can be turned easily by
tipping the cabinet slightly. Turn the leveling legs to the left
to raise the unit or to the right to lower it. (See Leveling and
door AlIgnment.)
NOTE: Installing on carpeting, soft tile surfaces, a platform
or weakly supported structure is not recommended.
2. Install this appliance in an area where the temperature is
between 55°F (13°C) and 110°F (43°C). If the temperature
around the appliance is too low or high, cooling ability may
be adversely affected.
3. Select a place where a water supply can be easily
connected for the automatic icemaker.
NOTE: The water pressure must be from 30 to 125 psi
or 207-862 kPa or 2.1-8.8 kgf/cm². If the refrigerator is
installed in an area with low water pressure below 30 psi,
you can install a booster pump to compensate for the low
pressure.
4.
inches between each side of the refrigerator and an
adjacent wall or surface.
5. Too small of a distance from adjacent surfaces may result
in lowered freezing capability and increased electricity
consumption charges. Provide the following unobstructed
- At least 2 inches between refrigerator back and wall.
- At least 2 inches between refrigerator top and overhead
surface.
8
2"
2"
Hide quick links:
Advertisement
