Auto Louver Grille (Optional Parts); Optional Parts Cable Binding; Customer Guidance - Fujitsu ARHG12LLTB Installation Manual

• Wiring arrangement
• Use 7 pins for receiver unit cable.
• At first, connect the receiver unit cable to the Receiver unit terminal (CN13).
] 1

9.5. Auto louver grille (Optional parts)

Connection method
• Connection terminal and jumper wires
Auto louver grille
terminal (CN11)
Jumper wires
• Cut Jumper wire JM2
• Wiring arrangement
Binder (Medium/Accessories)
Bind with this cable.
Opening this
knockout hole
Bushing (Accessory
of optional parts)
Auto louver grille cable
En-17
Binder (Medium/Accessories)
Bind with this cable.
Bushing (Accessory of optional parts)
Binder (Medium/Accessories)
] 1

9.6. Optional parts cable binding

Bushing**
Knockout hole
Auto louver
grille cable
Remote controller
cable
Other optional
parts cables
Binders*
Power supply
cable
Avoid touching the
ceiling with the wiring.
* Use an accessory of indoor unit or optional parts for binder.
** Use an accessory of optional parts for bushing.
• Do not bind the power supply cable and other cables together.
• T o protect the cable insulation after opening a knockout hole, remove any burrs from
the edge of the hole.

10. CUSTOMER GUIDANCE

Explain the following to the customer in accordance with the operating manual:
(1) Starting and stopping method, operation switching, temperature adjustment, timer, air
flow switching, and other remote controller operations.
(
2) Air filter removal and cleaning, and how to use the air louvers.
(3) Give the operating and installation manuals to the customer.
(4) If the signal code is changed, explain to the customer how it changed (the system
returns to signal code A when the batteries in the remote controller are replaced).
*(4) is applicable to using wireless remote controller.
Binder* Air inlet
Avoid covering the air
inlet with the wirings.
Ceiling
CAUTION