Mitsubishi MELDAS TRS50 Manual page 46

l
Note: The bellows should not be detached from the detector
Installation method
Install the O-ring (S75) to the
sensor flange.
Install an M4 hexagonal bolt with
hole to the coupling.
Align the motor shaft key with key
groove in the sensor bellows
Align the sensor positioning mark
with the motor mark off line.
Install the sensor to the motor
(using M5xO.8 screws).
Tighten the screw on the key groove
to secure the key so that it cannot
move.
Insert the sensor rubber plug
since the positions ofthesetwoparts standin a precise
relationship.