Advertisement
How to use Mobile:
1.
Use a screwdriver to unscrew the battery compartment cover, as shown.
2. Insert two (2) AA batteries.
3. Replace cover and use the screwdriver to replace the screws.
4. To turn on music, press the middle button.
5. To switch music, press the left button.
6. To control volume, press the right button.
Note: The arm can be moved to either side to make it easier to pick up your
baby from the bedside sleeper.
WARNING: Never use Mobile Arm as a handle. Do not hang anything on Mobile
Arm except for the included toys.
How to use Retractable Feet:
1.
If there is space between the floor and the bottom of your bed, as pictured in Figure 1, you can slide the
feet under your bed.
2. If there is no space, as is pictured in Figure 2, push the bedside sleeper's feet against your bed as shown to
allow them to retract.
Figure 1
3. IMPORTANT: ENSURE THERE IS NO GAP BETWEEN THE BEDSIDE SLEEPER AND YOUR BED. FAILURE TO DO SO MAY
RESULT IN INJURY OR DEATH. USE THE INCLUDED STRAP AND PLATE ASSEMBLY TO ELIMINATE ANY GAP.
INSTRUCTIONS BELOW
How to use the Attachment System
1.
This bedside sleeper should be only be used if your bed
height is between 24.44" and 27.56" (570 mm – 700 mm).
DO NOT use this product as a standalone sleeper.
2. Thread the strap through the openings on the plastic
plate, as shown.
3. Place plastic plate on the opposite side of your bed
to where you will be placing the bedside sleeper.
4. Run both sides of the strap underneath your bed. Let
the ends hang out on the side where you will be
placing the bedside sleeper.
5. Attach both ends of the strap to the legs of the
bedside sleeper.
Music On/Off Volume
Strap bracket
6
Figure 2
Plastic plate
Strap
Advertisement
