Table of Contents
Advertisement
Adjust Headset / Microphone and
Secure Cable
The headset consists of an earpiece, a microphone, a
clothing clip and a cable. The headset attaches to the audio
cable end of the voice cable which attaches to the Thor.
Align the audio connector and the headset quick connect
cable end. Firmly push the cable ends together until they
click and lock in place.
Do not twist the microphone boom when adjusting the
microphone. The microphone should be adjusted to be about
two finger widths from your mouth.
Make sure the microphone is pointed at your mouth. Note the
small "Talk" label near the mouthpiece. Make sure the Talk
label is in front of your mouth. The microphone cable can be
routed over or under clothing.
Under Clothing
Leave the cable exposed only at the top of the collar.
l
Be sure to leave a small loop of cable to allow move-
l
ment of your head.
Over Clothing
Use clothing clips to hold the cable close to your
l
body.
Tuck the cable under the belt, but leave a small loop
l
E-EQ-THORCEOGWW-A [ 14 ] Thor CE User Guide
where it goes under the belt.
Do not wear the cable on the front of your body. It may
l
get in your way or get caught on protruding objects.
Adjust Speaker Volume
The Thor has two speakers, located on the bottom of the unit.
Speaker volume can be adjusted to a comfortable level for
the listener by using the keypad or by changing parameters in
the Volume & Sounds control panel.
Using the Keypad
Note: Volume & Sounds (in Settings | Control Panel)
must be enabled before the following key sequences
can adjust the volume.
The volume is increased or decreased one step each time the
volume key sequence is pressed.
To adjust speaker volume, locate the 2nd key to the left of
the display. Press this key.
Adjust the speaker volume by pressing the:
Use the F9 key for volume Up and F10 key for volume Down.
Adjust volume until the speaker volume is satisfactory.
Press the Enter key to exit this mode.
The LED for the 2nd key blinks until the special editing mode
(set audio speaker volume) is complete.
Volume control using a keypad key press has six volume
settings that match those supported by the Volume and
Sounds Control panel. Volume does not "roll-over" from
minimum to maximum or from maximum to minimum.
Continuously holding down the up or down arrow keys does
not cause an automatic repeat of the up (or down) arrow key.
Using the Control Panel
Start | Settings | Control Panel | Volume & Sounds |
Volume
Change the volume setting and tap OK to save the change.
You can also select / deselect sounds for key clicks and
screen taps and whether each is loud or soft.
As the volume scrollbar is moved between Loud and Soft, the
Thor emits a tone each time the volume increases or
decreases in decibel range.
Advertisement
Table of Contents
