Programming The Detector - Kidde AirSense Stratos Micra 25 Installer's Handbook

3 Programming
the Detector
www.acornfiresecurity.com
The Stratos-Micra may be programmed from a PC when connected to the detector
via a standard 9-pin serial lead connected to the serial port of the computer and the
9 way socket at the base of the detector (see section 7.4, 'Connecting to a PC'). In
order to do this, it is necessary to install the remote control software onto the compu-
ter. A copy of the remote control software is contained on a disk supplied with each
detector. Install the software in accordance with the on-screen instructions. To open
the software, select "Start ➔ Programs ➔ AirSense ➔ Remote x" (where x is the version
of software installed). Access the drop-down list to the right hand side of the toolbar.
This defaults to "Detector 001". Scroll down this list to select the detector number
corresponding to the connected detector's address number if the address is other then
the factory default setting of 1 (see section 7.1).
The programmable functions are all accessed though the "Options ➔ Detector set-
tings" submenu or by clicking on the detector symbol in the remote software toolbar
as indicated below.
The following screen appears.
This window contains all the programmable functions for the Stratos-Micra.
To amend one of the programmable functions, go to the relevant tab in the "Function
settings" window, make the change and then click "OK". This will save the change to
the detector's internal firmware.
A list and explanation of the various functions is given overleaf, with the functions
grouped by the tab under which they appear.
Stratos-Micra • INSTALLER'S HANDBOOK • Iss. 16
www.acornfiresecurity.com
Page 7