MSI 845 Ultra Manual page 56

ARMD-HDD
CDROM
SCSI
NETWORK
BBS-0
BBS-1
BBS-2
BBS-3
Disabled
Note: Available settings for "1st/2nd/3rd Boot Device" vary depend-
ing on the bootable devices you have installed. For example, if you
did not install a floppy drive, the setting "Floppy" does not show up.
Try Other Boot Devices
Setting the option to Yes allows the system to try to boot from other devices if
the system fails to boot from the 1st/2nd/3rd boot device.
S.M.A.R.T. for Hard Disks
This allows you to activate the S.M.A.R.T. (Self-Monitoring Analysis & Re-
porting Technology) capability for the hard disks. S.M.A.R.T is a utility that
monitors your disk status to predict hard disk failure. This gives you an oppor-
tunity to move data from a hard disk that is going to fail to a safe place before
the hard disk becomes offline. Settings: Enabled and Disabled.
BootUp Num-Lock
This item is to set the Num Lock status when the system is powered on.
Setting to On will turn on the Num Lock key when the system is powered on.
Setting to Off will allow end users to use the arrow keys on the numeric keypad.
Setting options: On and Off.
as LS-120 or ZIP drive, that functions as a floppy
drive.
The system will boot from ARMD device, such as
MO or ZIP drive, that functions as hard disk drive.
The system will boot from the CD-ROM.
The system will boot from the SCSI.
The system will boot from the Network drive.
The system will boot from the first BBS (BIOS Boot
Specification) compliant device.
The system will boot from the second BBS (BIOS
Boot Specification) compliant device.
The system will boot from the third BBS (BIOS Boot
Specification) compliant device.
The system will boot from the fourth BBS (BIOS Boot
Specification) compliant device.
Disable this sequence.
3-9
BIOS Setup