Step 4: Install The Diva Isdn+Ct Software; Prepare To Install The Diva Isdn+Ct Software - Eicon Technology DIVA ISDN+CT Installation Manual

Step 4: Install the DIVA ISDN+CT
Software
This section describes how to install and configure the software for
DIVA ISDN+CT
.
• 'Prepare to install the DIVA ISDN+CT software' below.
• 'Install the DIVA ISDN+CT software' on page 10.
• 'Install the virtual modems' on page 14.
Note: Virtual modems allow you to use your DIVA ISDN+CT adapter for a
variety of applications such as fax, analog, and V.120 applications.

Prepare to install the DIVA ISDN+CT software

• Make sure Windows NT networking is installed
Before you install the DIVA ISDN+CT software, make sure that Windows NT
networking is installed on your system. If you do not have a network interface
card (which is required to complete the Windows NT networking installation),
install the MS Loopback adapter. This adapter appears in the list of available
adapters in the 'Network' dialog box, which is displayed during the
Windows NT networking installation.
• Make sure that the protocols you need to use are installed on your
computer
If you will be connecting to a Windows NT RAS server, you need to use one or
more of the following protocols: NetBEUI, TCP/IP, or IPX. You must use
protocols that are supported by the RAS server.
If you will be connecting to a TCP/IP router or an Internet service provider, you
need to use the TCP/IP protocol.
Follow the procedure below to install the required protocols.
To install protocols
Open the 'Network' dialog box: click 'Start > Settings > Control Panel'.
1.
Double-click the 'Network' icon.
Click the 'Protocols' tab.
2.
If all the required protocols appear in the 'Network Protocols' list, then they are
already installed on your computer. Click 'Cancel' to close the 'Network'
dialog box. Continue with 'Install the DIVA ISDN+CT software' on page 10.
You must follow these procedures
:
Step 4: Install the DIVA ISDN+CT Software N 9