Turn And Lane-Change Signals; Headlamp High/Low-Beam Changer; Flash-To-Pass - Buick 2006 LaCrosse Owner's Manual

Turn and Lane-Change Signals

To signal a turn, move the lever up or down. The lever
returns to its original position when the turn is completed.
To signal a lane change, raise or lower the lever until the
arrow starts to flash. Hold it there until the lane change is
completed. The lever will return to its original position
when released.
Arrows that flash rapidly when signaling for a turn or lane
change, or that fail to work, may indicate a burned-out
signal bulb or fuse. Other drivers will not see the signal.
See Front Turn Signal and Parking Lamps on page 5-53
and Taillamps, Turn Signal, Sidemarker, Stoplamps and
Back-up Lamps on page 5-54 for turn signal bulb
replacement procedures. Also see Fuses and Circuit
Breakers on page 5-93 for location of fuses.
A chime will sound if the turn signal is left on for more
than 3/4 mile (1.2 km).
3-8
An arrow on the instrument
panel cluster will flash in
the direction of the
turn or lane change.

Headlamp High/Low-Beam Changer

To change the headlamps from low beam to high beam,
push the turn signal/multifunction lever away from you.
To change the headlamps from high beam to low beam,
pull the turn signal lever toward you.

Flash-to-Pass

This feature lets you use your high-beam headlamps
momentarily to signal a driver in front of you that
you want to pass.
To use it, pull the turn signal/multifunction lever toward
you until the high-beam headlamps come on, then
release the lever to turn them off.
When the high beams are
on, a light on the instrument
panel cluster also will be on
if the ignition is on.