Turn And Lane-Change Signals; Headlamp High/Low-Beam Changer; Flash-To-Pass - Buick 2008 Allure Owner's Manual

Turn and Lane-Change Signals

To signal a turn, move the lever up or down. The lever
returns to its original position when the turn is completed.
To signal a lane change, raise or lower the lever until
the arrow starts to flash. Hold it there until the lane
change is completed. The lever will return to its original
position when released.
Arrows that flash rapidly when signaling for a turn
or lane change, or that fail to work, may indicate a
burned-out signal bulb or fuse. Other drivers will not see
the signal. See Taillamps, Turn Signal, Sidemarker,
Stoplamps and Back-up Lamps on page 5-58 for turn
signal bulb replacement procedures. Also see Fuses and
Circuit Breakers on page 5-109 for location of fuses.
A chime will sound if the turn signal is left on for more
than 3/4 mile (1.2 km).
3-8
An arrow on the instrument
panel cluster will flash
in the direction of the turn
or lane change.

Headlamp High/Low-Beam Changer

To change the headlamps from low beam to high beam,
push the turn signal/multifunction lever away from you.
To change the headlamps from high beam to low beam,
pull the turn signal lever toward you.

Flash-to-Pass

This feature lets you use your high-beam headlamps
momentarily to signal a driver in front of you that
you want to pass.
To use it, pull the turn signal/multifunction lever toward
you until the high-beam headlamps come on, then
release the lever to turn them off.
This light comes on in the
instrument panel cluster
if the high beam lamps
are turned on while
the ignition is in ON/RUN.