Advertisement
STEP 2 LOCATING AND DRILLING THE WIRE HOLE
a. On the hinge-side of door, mark a horizontal centerline at the desired height for the TouchBar.
b. Place a channel end cap bracket over the centerline.
c. Center wire hole in the adaper plate with the centerline that was marked on door. (See below)
d. Mark center of wire hole and center of one mounting hole.
d. Drill a 5/8" wire access hole at wire hole mark. DO NOT DRILL WIRE HOLE THRU DOOR.
WIRE HOLE
LOCATION:
Note that hole
size and loca-
tion depends on
fastener type
(SEE STEP 3).
STEP 3 MARK AND DRILL MOUNTING HOLES
Fasten TouchBar to door. There are three methods of fastening the device to the door:
USE A LEVEL WHEN MARKING HOLES
SELF DRILLING SELF TAPPING SCREWS:
a. Hold device in position determined in step 2.
b. Using a powered screw driver, screw in one screw on one side.
c. Level the device. Secure other side with self drilling screw.
d. Install remaining two screws.
4
WIRE HOLE IS
ALWAYS ON
HINGE SIDE
OF FRAME
SHK Option for REX
ALUMINUM DOOR MOUNTING SHIMS
MUST BE USED FOR ALL NARROW
STYLE ALUMINUM DOORS. THEY
CAN BE OMITTED FOR HOLLOW
METAL AND WOOD DOORS.
Advertisement
