Receiver-Based Programming - Remote Control GENIUS JA 332 Programming Manual

Receiver-based programming:

1. Open the casing of your receiver. It is located next to your motor.
2. Press simultaneously buttons P1 and P2 on your new remote control (fig A). The LED light on
the new remote control blinks. Let the buttons go.
3. While the LED light on your new remote is blinking, press the programming button on your
receiver circuit board (fig B). Keep it pressed down. The LED light on the receiver blinks.
4. While keeping the programming button on the receiver pressed down, press a button on
your new remote control during the blinking of the LED light on your new remote. Keep it
pressed down. The LED light on the receiver remains lit constantly and then turns off (fig C).
Let the buttons go.
5. Wait 10 seconds.
6. Your new remote control is programmed.
http://www.remotecontrol-express.com
Programming Manual
- TEL : +44 (0) 207 399 7782 - FAX : +44 (0) 207 927 3151