Media Chassis Installation (Ics-110/115A); Optional Din-Rail Installation - Planet ICS-11 Series User Manual

2.2.3 Media Chassis Installation (ICS-110/115A)

To install the Serial Server in a 10-inch or 19-inch standard rack, follow the instructions described below.
Step 1:
Place your Serial Server on a hard flat surface, with the front panel positioned towards your front side.
Step 2:
Carefully slide in the module until it is fully and firmly fitted into the slot of the chassis; the Power LED of the Serial
Server will turn ON.
1. Never push the Serial Server into the slot with force; it could damage the chassis.
2. The Media Converter Chassis supports hot-swap; there is no need to turn off the
whole chassis before sliding in the new converter.
Caution

2.2.4 Optional DIN-rail Installation

There are two DIN-rail holes on the left side of the Serial Server that allows to be easily installed by DIN-rail mounting. PLANET
optional DIN-rail mounting kit – RKE-DIN -- can be ordered separately. Refer to the following steps for the DIN-rail mounting of
the Serial Server:
Step 1:
Screw the DIN rail on the Serial Server
User's Manual of ICS-11x Serial Device Server Series
Figure 3-2: Insert Serial Server into an available slot
23