Installation - Haier HOA-T10NW7M Instruction Manual

INSTALLATION

Installing the oven
● The kitchen area should be dry and aired
and equipped with efficient ventillation.
When installing the oven, easy access to
all control elements should be ensured.
● This is a Y–type design built–in oven,
which means that its back wall and one
side wall can be placed next to a high
piece of furniture or a wall. Coating or
veneer used on fitted furniture must be
applied with a heat–resistant adhesive
(100°C). This prevents surface deforma-
tion or detachment of the coating.
● Hoods should be installed according to
the manufacturer's instructions.
● Make an opening with the dimensions
given in the diagram for the oven to be
fitted.
● Make sure the mains plug is disconnected
and then connect the oven to the mains
supply.
● Insert the oven completely into the ope-
ning without allowing the four screws in
the places shown in the diagram to fall
out.
● The appliance must not be installed be-
hind a decorative door in order to avoid
overheating.
50