Activating Fireboy-Xintex Carbon Monoxide Alarm (Battery Only Models); Testing; Single Marine Standard Series Alarms; Marine Interconnect-Relay Series Alarms - Fireboy- Xintex CMD6-MB Owner's Manual & Installation Instructions

Activating Fireboy-Xintex Carbon Monoxide Alarm
1. Hold "Test/Mute" button for 10 seconds. The Green LED will turn on.
2. Press the "Test/Mute" button 5 times. The Green and Red LEDs will flash, and the horn
will sound.
The CO Alarm is now activated. The Green LED will flash once every 180 seconds.

Testing

Test the CO Alarms no less than once per week.

Single Marine Standard Series Alarms

Press "Test/Mute" button until Green LED turns on and release. The alarm will simulate 2 alarm
cycles (2 sets of 4 Beeps, 5 sec. Silence between). The Red LED will flash once every 5 seconds.

Marine Interconnect-Relay Series Alarms

Press and hold the "Test/Mute" button for 60 seconds (1 minute). The Red LED will flash once
every 5 seconds on the CO Alarm used to test. The Red and Green LED will flash once every 5
seconds on the interconnected CO Alarms. All interconnected CO Alarms will alarm within 1
minute. All equipment connected to the alarming unit will turn OFF.

Maintenance

Clean without solvents weekly. Wipe surface of unit with a damp cloth.
16
Part Number 18160, F, 06/29/2021