Installation; Installing The Mounting Base - Fireboy- Xintex CMD6-MB Owner's Manual & Installation Instructions

Installation

Installing the Mounting Base

•
Mounting Base should be installed vertically when installing CO Alarm on a wall.
•
Use appropriate length #6, Pan Head screws to secure Mounting Base.
•
Do not over-tighten.
•
Drill appropriate size hole (0.38" (9.5mm) Max) for wired models to accommodate the
wires. If using a connector on the wires, a larger hole may be needed. Offset the hole
to the side of the Mounting Base with the wire slot, as shown.
Wire Slot
Part Number 18160, F, 06/29/2021
Drill Location for wiring.
0.38" (9.5mm)
(9.5mm) Max
Mounting Hole
2 PLCS.
12
Max0.38"