Connecting Alarm To Mounting Base - Fireboy- Xintex CMD6-MB Owner's Manual & Installation Instructions

Installation Continued

Connecting Alarm to Mounting Base

•
Align Mounting holes of CO Alarm with the posts on the Mounting Base.
•
Feed wires through the Mounting Base and mounting surface.
•
Press CO Alarm against mounting surface and turn clockwise, approximately 25°.
A UNIT THAT HAS BEEN DEACTIVATED WILL NOT BE ABLE TO BE INSTALLED ONTO THE MOUNTING
PLATE.
After installation is complete, attach one of the enclosed "Warning" stickers to the wall next to
the alarm. Place the other sticker near a source of fresh air where you would gather after an
alarm indicates the presence of carbon monoxide. The phone numbers of emergency services
and qualified technicians, as well as the Replacement Date, should be added to both stickers.
Mounting Hole
NOTE:
13
Part Number 18160, F, 06/29/2021
Post