Safety, Environmental, And Electronic Emissions Notices - IBM Proventia Management SiteProtector SP2001 Hardware Configuration Manual

Safety, Environmental, and Electronic Emissions Notices

Safety notices may be printed throughout this guide. DANGER notices warn you
of conditions or procedures that can result in death or severe personal injury.
CAUTION notices warn you of conditions or procedures that can cause personal
injury that is neither lethal nor extremely hazardous. Attention notices warn you
of conditions or procedures that can cause damage to machines, equipment, or
programs.
DANGER notices
DANGER
DANGER
DANGER
DANGER
x
SiteProtector System: SP2001 Hardware Configuration
To prevent a possible shock from touching two surfaces with different
protective ground (earth), use one hand, when possible, to connect or
disconnect signal cables. (D001)
Overloading a branch circuit is potentially a fire hazard and a shock hazard
under certain conditions. To avoid these hazards, ensure that your system
electrical requirements do not exceed branch circuit protection requirements.
Refer to the information that is provided with your device or the power
rating label for electrical specifications. (D002)
If the receptacle has a metal shell, do not touch the shell until you have
completed the voltage and grounding checks. Improper wiring or grounding
could place dangerous voltage on the metal shell. If any of the conditions are
not as described, STOP. Ensure the improper voltage or impedance conditions
are corrected before proceeding. (D003)
An electrical outlet that is not correctly wired could place hazardous voltage
on the metal parts of the system or the devices that attach to the system. It is
the responsibility of the customer to ensure that the outlet is correctly wired
and grounded to prevent an electrical shock. (D004)