Buick 1998 Century Owner's Manual page 297

Then:
1. Install the new bulbs into the applique sockets (B).
2. Connect the applique to the lid.
3. Reconnect the wing nuts to the studs on the applique
and hand-tighten.
4. Close the trunk lid.
Dome Lamp
Back-up Lamp
The back-up lamps are located in the
tyunk
lid applique.
(Refer to the
trunk
lid applique removal procedure earlier
in this section for graphic and further instructions.)
1. Remove the trunk lid applique.
2. Twist and pull the back-up lamp socket from the
3. Twist and pull the bulb from the back-up
To install the new bulb:
trunk lid applique.
lamp socket.
1. Twist and push the bulb into the back-up
2. Twist and push the back-up lamp socket into the
3. Reinstall the trunk lid applique.
lamp socket.
trunk lid applique.
1.
2.
3.
4.
5 .
6.
7.
8.
Grasp the front center and rear center positions
of the dome lamp housing and squeeze together
until the housing releases from the base plate. A
flat-bladed screwdriver may be necessary to pry
the assembly loose.
Lift the plastic locking tab on the electrical
connector and pull the connector from the dome
lamp assembly.
Grasp the bulb housing located in the center of the
assembly and pull straight up.
Pull the bulb out of the socket.
Push in a new bulb.
Replace the socket into the dome lamp assembly.
Reconnect the dome lamp assembly to the wiring
harness, making sure the connector tab snaps
into place.
Reposition the dome lamp assembly to the roof, and
gently push the assembly into the base plate.
For any bulb changing procedure not listed in this
section, contact your dealer service department.
6-37