Zenith HydroTap G5 Quick Start Installation Manual page 7

SECTION 3: WARNINGS & REGULATORY INFORMATION
• Do not over tighten plumbing and hose connections.
• Braided hoses supplied cannot be lengthened.
• Be aware of the risks of hazards which could cause harm when handling
compressed CO2. Assess the risks before starting the installation.
• Do not proceed with a CO2 cylinder change if the seals are damaged.
Take care not to cross thread the regulator, a cross threaded regulator
poses a potential hazard.
• Care must be taken when working with high pressure carbon dioxide,
and in no case should the normal operating pressure of 3.0 bar be
exceeded.
• The power cord and general power outlet must be in a safe and
accessible position after installation. When positioning the appliance,
ensure the power supply cord is not trapped or damaged. If the power
supply cord is damaged it must be replaced by a Zenith service provider
or a qualified electrician.
• Do not locate multiple portable socket-outlets or portable power
supplies at the rear of the appliance.
• For safe operation, the HydroTap is designed to be installed,
commissioned and used within 48 hours. Should the HydroTap not be
required for an extended period of time (72 hours or more), do not fill
and commission the HydroTap until ready for first use.
• For water taste and quality reasons, following any non-use period of
more than 72 hours, Zenith recommends to perform a system flush.
Failure to flush the system may affect water quality.
Quick Start Installation Guide
807120NZ v1.00 01.21 G5 C CS Quick Start Guide
7