Zenith HydroTap G5 Quick Start Installation Manual page 19

SECTION 9: Install the CO2 cylinder and regulator
Test for leaks
Care must be taken when working with high pressure carbon
!
dioxide, and in no case should the normal operating pressure of
3.0 bar be exceeded.
• Apply soapy water to the gas connections (see below), using a brush.
• If there is a leak, bubbles will appear.
• In the case of a leak, turn OFF the gas, clean away the soapy residue and
re-seal the leaking connection.
Test for leaks
in these areas
Quick Start Installation Guide
807120NZ v1.00 01.21 G5 C CS Quick Start Guide
19