AEG ITE42600KB User Manual page 63

3.6 Installation of more than one
hob
Supplied accessories: heat-resistant
silicone, rubber shape, sealing stripe.
Use only a special heat-resistant
silicone.
The worktop cutout
Distance minimum 50 mm
from the wall
Length 490 mm
Width the sum of all widths of appliances
that you install minus 20 mm
Example:
+ -
360 mm 360 mm
Assembly
• Calculate correct cutout dimensions.
• Prepare the worktop cutout.
• Place the appliances on a soft surface
(e.g. a blanket) with the bottom side up.
• In the case of the Teppan Yaki, attach the
supplied seal stripe to its lower edge,
along the outer edge of the glass ceramic.
Loosely screw the fixing plates into the
correct holes in the protection casing.
• Insert the first appliance into the worktop
cutout. Mount the connection bar under
the appliance so that a half of its width is
still visible - it will support the next
appliance.
=
20 mm 700 mm
• For the Teppan Yaki, loosely screw in the
fixing plates to the worktop from below (at
the front and the rear of the appliance).
• Insert the next appliance into the worktop
cutout. Make sure that the front edges of
the appliances are on the same level.
• Fix appliances other than Teppan Yaki
with the use of snap-in springs.
• At the end, tighten the screws of the
Teppan Yaki.
• Use silicone to seal the gaps between the
appliances and those between the
appliances and the worktop.
• Press the rubber shape firmly against the
glass ceramic and move it slowly along
the edges to squeeze out excess silicone.
• Put some soapy water on the silicone and
smoothen out the edges with your finger.
• Do not touch the silicone until it hardens,
it can last for about a day.
• Carefully remove the silicone squeeze-out
with a shaving razor.
• Clean the glass surface.
ENGLISH 63