BMW 2009 M5 Owner's Manual page 215

Table of Contents

Advertisement

Fast measurement
In addition to the automatic measurement, you
can also determine the current oil level manu-
ally, e.g. after adding engine oil, but with a lower
degree of measuring accuracy.
1.
With the engine at operating temperature,
i.e. after at least 6 miles/10 km of uninter-
rupted driving, park the vehicle in a horizon-
tal position.
2.
Allow the engine to run at idle.
3.
Press the BC button on the turn signal lever
repeatedly until the oil level display is
shown in the instrument cluster.
4.
Press the BC button for at least 2 seconds.
The oil level is determined. A clock symbol
is displayed during the measurement.
5.
After approx. 1 minute the current oil level is
displayed.
Displaying via iDrive
iDrive, for operating principle refer to page 16.
1.
Press the
button.
This opens the start menu.
2.
Press the controller to open the menu.
3.
Turn the controller until "Info sources" is
selected and press the controller.
4.
Turn the controller until "Service Info" is
selected and press the controller.
Online Edition for Part no. 01 41 2 600 738 - © 08/08 BMW AG
5.
Change to upper field if necessary. Turn the
controller until "Service requirements" is
selected and press the controller.
6.
Change to the second field from the top if
necessary. Turn the controller until "Engine
oil level" is selected and press the control-
ler. The oil level is displayed.
Possible messages
>
"Engine oil level O.K."
>
"No measurement available: Updating
engine oil level measurement...":
The engine oil level is measured. This pro-
cess can take approx. 1 minute when
stopped on a level surface with the engine
running and approx. 5 minutes while driv-
ing.
If the engine oil has been topped off, the
measurement of the oil level can take up to
30 minutes.
>
"Oil level at the minimum! Refill with 1 quart
of engine oil.":
Add a maximum of 1 US quart/1 liter of
engine oil at the next opportunity, refer also
to Adding engine oil below. Add at least
0.5 US quart/0.5 liters of oil; otherwise, the
oil level check cannot reliably display the
new oil level.
If the oil level displayed is below minimum,
add engine oil immediately. Failure to do so
may lead to engine damage.
>
"Engine oil level too high"
Have the vehicle checked immedi-
ately, otherwise engine damage may
result if too much oil has been
>
"Please observe recalculated service inter-
val for engine oil":
*
:
added.<
213

Advertisement

Table of Contents
loading

This manual is also suitable for:

2010 m5

Table of Contents