Table of Contents
Advertisement
Components of the M Mobility System
1
Sealant bottle and label with speed restric-
tion
2
Filling hose from sealant bottle to wheel
3
Connector and cable for the cigarette
lighter socket/power socket
4
Holder for the sealant bottle
5
Compressor
6
On/off switch
7
Pressure gauge for displaying the tire infla-
tion pressure
8
Screw on pressure gauge to reduce tire
inflation pressure
9
Hose to connect compressor and sealant
bottle or compressor and wheel
The connector, cable and connection hose are
stored in the compressor housing.
Using the M Mobility System
To repair a flat tire with the M Mobility System,
proceed as follows:
>
Fill the sealant, refer to page 218.
>
Distribute the sealant, refer to page 218.
>
Produce the tire inflation pressure, refer to
page 219.
218
Online Edition for Part no. 01 41 2 600 999 - © 08/08 BMW AG
Filling the sealant
Strictly follow the specified sequence,
otherwise the sealant may escape under
high
pressure.<
1.
Shake the sealant bottle.
2.
Screw connection hose 9 onto the connec-
tor of the sealant bottle.
3.
Ensure that screw 8 on the pressure gauge
is closed.
4.
Unscrew the dust cap from the valve of the
defective wheel and screw filling hose 2 of
the sealant bottle onto the valve.
5.
Insert the sealant bottle into the housing of
the compressor so that the bottle is upright.
6.
Ensure that the compressor is switched off,
position 0.
7.
Insert connector 3 into the cigarette lighter
socket/power socket in the interior of the
vehicle, refer to page 107.
8.
With the ignition switched on:
Switch on the compressor and let it run for
approx. 3 minutes to fill the sealant. The
inflation pressure of the tire after filling is
unimportant.
9.
Switch off the compressor.
10.
Detach the hoses from the sealant bottle
connector and from the tire valve.
Return the M Mobility System to its storage
location in the vehicle.
Distributing the sealant
Immediately drive approx. 2 miles/3 km to
evenly distribute the sealant in the tire.
Advertisement
Table of Contents
