Distributing The Sealant; Snow Chains - BMW Coupe 4 Series Owner's Manual

3. Wrap the empty sealant container and con‐
nection hose in suitable material to avoid
dirtying the cargo area.
4. Stow the Mobility System back in the vehi‐
cle.

Distributing the sealant

Immediately drive approx. 5 miles/10 km to en‐
sure that the sealant is evenly distributed in the
tire.
Do not exceed a speed of 50 mph/80 km/h.
If possible, do not drive at speeds less than
12 mph/20 km/h.
To correct the tire inflation pressure
1. Stop at a suitable location.
2. Screw the connection hose onto the tire
valve stem.
3. Attach the connection hose directly to the
compressor.
I n f o r ma t i o n P r o v i d e d b y :
Online Edition for Part no. 01 40 2 960 520 - II/15
Wheels and tires
4. Insert the connector into a power socket
inside the vehicle.
5. Correct the tire inflation pressure to
2.5 bar.
▷ Increase pressure: with the ignition
turned on or the engine running, reel
on the compressor.
▷ To reduce the pressure: press the but‐
ton on the compressor.
Continuing the trip
Do not exceed the maximum permissible
speed of 50 mph/80 km/h.
Reinitialize the Flat Tire Monitor.
Reinitialize the Tire Pressure Monitor.
Replace the defective tire and the sealant con‐
tainer of the Mobility System as soon as possi‐
ble.

Snow chains

Fine-link snow chains
Only certain types of fine-link snow chains
have been tested by the manufacturer of the
vehicle, classified as road-safe and approved.
Information about the approved snow chains
are available from the service center.
Use
Use only in pairs on the rear wheels, equipped
with the tires of the following size:
▷ 225/50 R 17.
Mobility
197