Distributing The Sealant - BMW M2 Owner's Manual

7. With the ignition switched on or the engine
running, switch on the compressor.
Let the compressor run for max. 10 minutes to fill
the tire with sealant and achieve a tire inflation
pressure of approx. 2.5 bar.
While the tire is being filled with sealant, the tire
inflation pressure may sporadically reach approx.
5 bar. Do not switch off the compressor at this
point.
If a tire inflation pressure of 2 bar is not reached:
1. Switch off the compressor.
2. Pull the connector out of the power socket
inside the vehicle.
3. Unscrew the filling hose from the tire valve.
4. Drive 33 ft/10 m forward and back to distrib‐
ute the sealant in the tire.
5. Inflate the tire again using the compressor.
If a tire inflation pressure of 2 bar cannot be
reached, contact your dealer's service center
or another qualified service center or repair
shop.
Stowing the Mobility System
1. Unscrew the filling hose of the sealant con‐
tainer from the tire valve.
2. Pull the compressor connector out of the
socket inside the vehicle.
3. Unscrew the connection hose of the com‐
pressor from the sealant container.
4. Connect the filling hose of the sealant con‐
tainer previously connected to the tire valve
with the available connector on the sealant
container.
Online Edition for Part no. 01402720665 - II/19
Wheels and tires
This prevents leftover sealant escaping from
the sealant container.
5. Wrap and store the sealant container in suita‐
ble material to avoid dirtying the cargo area.
6. Stow the Mobility System back in the cargo
area.

Distributing the sealant

Immediately drive approx. 5 miles/10 km to en‐
sure that the sealant is evenly distributed in the
tire.
Do not exceed the permissible maximum speed
of 50 mph/80 km/h.
If possible, do not drive at speeds less than
12 mph/20 km/h.
Correcting the tire inflation
pressure
1. Stop at a suitable location.
2. Screw the connection hose of the compres‐
sor directly onto the tire valve stem.
3. Insert the connector into the power socket in‐
side the vehicle.
4. Correct the tire inflation pressure to 2.5 bar.
▷ Increase tire inflation pressure: with the ig‐
nition switched on or the engine running,
switch on the compressor.
▷ Reduce tire inflation pressure: press the
button on the compressor.
Continuing the trip
Do not exceed the maximum permissible speed
of 50 mph/80 km/h.
Reinitialize the Flat Tire Monitor.
Reset the Tire Pressure Monitor TPM.
Replace the nonworking tire and the sealant con‐
tainer of the Mobility System at the next opportu‐
nity.
MOBILITY
223