Table of Contents
Advertisement
Using pathway and turning lines
1.
Position the vehicle so that the turning lines
guide within the limits of the parking space.
2.
Turn the steering wheel so that the pathway
lines cover the corresponding turning lines.
This results in a steering wheel position that
makes full use of the smallest possible turning
circle of the vehicle when parking.
Virtual camera panning
The displayed picture area is dependent on the
current speed:
At low speeds, the camera view is panned
toward the street, and at higher speeds toward
the horizon.
This enables the currently relevant picture area
to be shown enlarged on the Control Display.
To activate the virtual camera panning, select
the camera view "Camera view: full screen",
refer to Displays on page 85.
Obstacle marking
Spatially shaped markings are shown in the pic-
ture of the rear view camera. Their stepped col-
ors correspond to the markings of the Park Dis-
tance Control and support you in estimating the
distance to the object shown.
The obstacle marking is deactivated when driv-
ing in reverse from approx. 12 mph/20 km/h.
Activating driver assistance functions
The driver assistance functions can be active at
the same time. The zoom function for trailer
towing can only be activated individually with
the rear view camera switched on.
84
Online Edition for Part no. 01 41 0 015 021 - © 11/07 BMW AG
With rear view camera switched on
iDrive, for operating principle refer to page 16.
1.
Press the controller.
2.
Select the desired function and press the
controller.
You can also adjust the brightness of the cam-
era view.
With rear view camera switched off
1.
Press the
button.
This opens the start menu.
2.
Press the controller to open the menu.
3.
Select "Settings" and press the controller.
4.
Select "Vehicle / Tires" and press the con-
troller.
5.
Change to upper field if necessary. Turn the
controller until "Maneuvering aids" is
selected and press the controller.
6.
Select "Settings" and press the controller.
7.
Select the desired functions and press the
controller.
The settings are stored for the remote control
currently in use.
Advertisement
Table of Contents
