BMW 2008 X6 Owner's Manual page 65

> Downshifting: press on one of the shifting
paddles, arrows –.
Upshifts and downshifts are executed only
when they will result in a plausible combination
of engine and vehicle speed; thus, for example,
a downshift that would cause the engine to
overrev will not be executed by the system. The
selected gear is briefly displayed in the instru-
ment panel, followed by the current gear.
Manually releasing and engaging
transmission lock
In case of a power failure, e.g. when the
battery is drained or disconnected, or an
electrical malfunction, the transmission lock
must be manually released, as otherwise the
rear wheels are blocked and the vehicle cannot
be towed.<
Step on the brake when manually releas-
ing the transmission lock; otherwise,
there is a danger of the vehicle
The transmission lock should only be released
for towing. Reengage the transmission lock
after parking the vehicle at its destination.
If it also becomes necessary to manually
release the parking brake, follow this sequence:
1. Secure the vehicle against rolling.
2. Manually release the parking brake, refer to
page 60.
3. Manually release the transmission lock of
the automatic transmission.
Releasing
1. Slide back the cover of the cup holder and
remove the floor mat on the bar between
the cup holders, arrow 1.
Online Edition for Part no. 01 41 0 015 021 - © 11/07 BMW AG
2.
3.
4.
5.
rolling.<
wise there is a danger of the vehicle
Locking
1.
2.
3.
4.
Information on jump starting and towing, from
page 253.
Open the cover in the bottom of the cup
holder with the releasing tool from the
onboard tool kit, page 245, refer to arrow 2.
If necessary, unlock the lock
grated key of the remote control, refer to
page 28, and remove it.
Insert the releasing tool into the opening,
arrow 3.
Turn the releasing tool as far as possible,
arrow 4, and then press downward and
leave it in. The transmission lock is
released.
Engage the transmission lock after park-
ing the vehicle at its destination. Other-
Pull out the releasing tool.
The transmission lock is engaged again.
If necessary, insert the lock
Close the cover in the bottom of the cup
holder and lay in the mat again.
Close the cover of the cup holder and stow
the releasing tool.
*
with the inte-
rolling.<
*
and lock it.
63