Ha100 Deployment Methods; Powering And Connecting The Ha100; Figure 2: Basic Connection Setup Of The Ha100 - Grandstream Networks HA100 Deployment Manual

HA100 DEPLOYMENT METHODS

Before deploying and configuring the HA100, the unit needs to be properly powered up and connected.
This section describes detailed information about the HA100 interfaces and the steps needed for installing
and connecting the HA100. This section provides the connection types and steps needed for connecting
the HA100 with 2 UCM6510s.

Powering and Connecting the HA100

The external connections are used for the following purposes:
•
Powering up the HA100.
•
Network connection.
•
PSTN lines connection.
•
Analog/Fax connection.
•
Digital (T1/E1/J1) connections.
Please refer to the following steps for basic connection setup of the HA100:
1. Connect one end of an Ethernet cable to the WAN port of the HA100 and the other end of the cable
to the uplink of a hub or switch.
2. Connect 12V power adapter to the 12V power port on HA100 and the other end to a power outlet.
Please refer to the following steps for optional connections on the HA100:
1. For PSTN connection: Connect a PSTN cable to the FXO external port on HA100.
2. For Analog phone/Fax connection: Connect analog phone or FAX machine to the FXS external
port on HA100.
3. For T1/E1/J1 connection: Connect your digital connection cable from the service provider side to
the T1/E1/J1 external port on HA100.

Figure 2: Basic Connection Setup of the HA100

HA100 Deployment Guide
P a g e | 4