Ha100 Deployment Methods; Method 1: Backup And Restore Configuration - Grandstream Networks HA100 Deployment Manual

Hide thumbs Also See for HA100:

Table of Contents

HA100 Deployment Methods

There are two deployment methods for adding an HA100 and a secondary UCM6510 to an existing

UCM6510 setup:

•

Step 1: Create a full backup for UCM A (backup_A_1). (This backup is created in case any

configuration is lost during upgrading in step 2).

•

Step 2: Upgrade UCM A to firmware version 1.0.15.16 or higher. Then create a full backup on UCM

A (backup_A_2).

•

Step 3 : Upgrade UCM B to the same firmware as UCM A, and restore "backup_A_2" to UCM B.

UCM A and UCM B should now have the same configuration and data.

•

Step 4: Connect all the cables as described in [UCM6510 and HA100 Connection] section

"HA100 Connection". Make sure all ports A in HA100 are connected to UCM A, and all ports B are

connected to UCM B.

•

Step 5: Connect the Heartbeat port between UCM A and UCM B.

•

Step 6: Make sure UCM A, UCM B and HA100 are up and running. Access UCM_A's web UI,

enable HA under System Settings→HA.

Note: Do not check "Hardware Scan" and "Fault Switch" in this step. You can select those two

options after step 7.

•

Step 7: Save and apply changes before rebooting. After rebooting, UCM A will display "Master"

and UCM B will display "Slave" on each LCD. It will take about 5mins or longer for data

synchronization. Once this is completed, the user can access the UCM_A's web UI and perform

other operations.

Note: The method 1 is the preferred method.

HA100 Deployment Guide

P a g e

Table of Contents