Connecting The Ha100 With 2X Ucm6510S; Setup Requirements; Ucm6510 And Ha100 Connection - Grandstream Networks HA100 Deployment Manual

Hide thumbs Also See for HA100:

Table of Contents

4. For LAN connection: Connect one end of the Ethernet cable to the LAN external port on HA100

and the other end to a switch, hub or etc.

Connecting the HA100 with 2x UCM6510s

In a connection between HA100 and 2x UCM6510s, one UCM6510 will function as the primary server and

provide online services. The other UCM6510 will function as a backup server and will not provide services

until the primary server is down.

The internal connection setup will require the following items:

•

5 RJ45 cables (Ethernet).

•

2 RJ48 cables (T1/E1/J1).

•

8 RJ11 cables (If using PSTN trunks and/or analog devices)..

•

2 USB-to-RS485 serial cables.

•

2 UCM6510 (UCM A and UCM B) using firmware 1.0.15.13 or higher.

Please refer to followings steps for the basic internal connections between HA100, UCM A(Master) and

UCM B(Slave):

1. Connect respectively UCM A's Line port (FXO), Phone port (FXS), E1/T1/J1 port, WAN port and

LAN port to HA100's FXO-A port, FXS-A port, E1/T1/J1-A port, WAN-A port, and LAN-A port.

2. Use the USB-to-RS485 serial cable to connect UCM A's USB port to the RS485-A port on HA100.

3. Connect respectively UCM B's Line port (FXO), Phone port (FXS), E1/T1/J1 port, WAN port and

LAN port to HA100's FXO-B port, FXS-B port, E1/T1/J1-B port, WAN-B port, and LAN-B port.

4. Use the USB-to-RS485 serial cable to connect UCM B's USB port to the RS485-B port on HA100.

5. Use Ethernet cable to connect the Heartbeat ports on Primary UCM A and Backup UCM B.

Note: Since the UCM6510 has only one USB port, users are recommended to use a USB hub if they want

to use an external USB storage device along with the HA100 module.

The following diagram illustrates the connection between the HA100 and 2 UCM6510 PBXs.

HA100 Deployment Guide

P a g e

Table of Contents