Advertisement
FRT:
ABS 18 und ASB 18
3.2. Trouble shooting
Failure
1. Machine does not start
2. No speed of the actuator
(acceleration).
3. Drive shaft continues to turn when the
actuator is released (no brake).
4. Machine runs, drive shaft can be held
(no torque)
5. Strong gear noise, sized.
6. When using the coupling for screw
action, the adjustment ring turns.
7. Drill chuck does not run round.
8. Striking impact too weak despite strong
contact pressure.
9. Defective spindle lock.
Drill chuck cannot be opened and closed
with one hand.
Relief
Check charge condition of battery, if
necessary recharge battery.
Clean the contacts on the machine and battery.
Check electronic actuator.
Replace the entire electronic actuator (60).
Replace the electronic actuator (60).
Permit speed 1 or 2 to snap in and/or
replace the drive motor (50) and/or gear (40).
Replace the entire gear (40).
Replace the retaining ring (30).
0.4 mm beat is permissible measured at a
distance of 25 mm in front of drill chuck end. In
case of excess, replace the striking train (40).
Replace entire gear (40).
Change entire gear (40).
Alle Rechte bei FEIN, insbesondere für den Fall der Schutzrechtsanmeldung.
Jede Verfügungsbefugnis wie Kopieren und Weitergaberecht liegt bei FEIN.
Sahre / MVK 05 / 07
Advertisement
