Inflating With The Low Pressure Hose - Westfalia ALK 18 Original Instructions Manual

urement of the fluctuating pressure between the item and the high
pressure hose. To get an accurate reading, stop inflating and follow
above instructions for reading the air pressure.
 Set the main switch (3) to II to start inflating.
 The compressor will run until the target pressure is slightly exceed-
ed, then it will decrease the pressure to reach the target pressure.
 When the desired pressure is reached and the compressor has
stopped set the main switch to O.
 Remove the hose and store in hose wrap on the right side of the
compressor.
 Turn off the display by pressing and holding the (+) and (-) buttons
until the display turns off.
Note: Stand at least half a metre away from item being inflated.
Use of the Adaptors
The high pressure air hose can be used with the provided adaptors to
inflate a variety of items.
 Insert the adaptor (or needle) into the air chuck and push the air
chuck clamp down until it locks into place. Inflate to the desired
pressure.
 Remove the adaptor by lifting the air chuck clamp up and pulling the
adaptor (or needle) from the air chuck.

Inflating with the low Pressure Hose

The low pressure hose ls used to inflate low pressure items, such as air
mattresses, pools, and floats.
Note: A pinch valve adaptor (7) comes as part of the inflating nozzle
assembly that is attached to the end of the low pressure hose. The
pinch valve adaptor is used for items that have a smaller air opening or
pinch valve. Insert pinch valve adaptor into pinch valve, insuring that
the tip of the adaptor is inserted past the inner "flap" inside the valve.
When inflating, ensure that the tip is not blocked during inflation.
 To attach the low pressure hose, align the slots in the hose with the
pins on the sides of the inflation flange (5).
 Turn the hose clockwise as far as it will turn.
 Use the suitable adaptor to connect the hose to the item to be
inflated.
Operation
20