CHAPTER 3
B. Top Cover Open Detection Switch
1) Following the front cover removal proce-
dure described on Page 3-4, remove the
front cover.
2) Disconnect the connector, remove the
switch cover, and then take out the top
cover open detection switch.
Connector
Switch cover
Top cover open detection switch
Figure 3-5-2
3 - 12
C. Swing Guide Close Detection Switch
1) Following the staple tray unit removal
procedure described on Page 3-6,
remove the staple tray unit.
2) Remove the 2 screws and then the
mounting plate.
Screws
Mounting plate
Figure 3-5-3
3) Remove the 2 screws and then the
swing guide close detection switch.
Screws
Swing guide close detection switch
Figure 3-5-4