Reversing Roller Drive - Canon STAPLER STACKER SS-72 Service Manual

CHAPTER 3
D. Reversing Roller Drive Solenoid
1) Following the rear cover removal proce-
dure described on Page 3-4, remove the
rear cover.
2) Remove the screw, disconnect the con-
nector, and then take out the reversing
roller drive solenoid.
Screw
Connector
Reversing roller drive solenoid
Figure 3-7-6
3 - 26
E. Face-up Deflector Solenoid
1) Following the power
removal procedure described on Page 3-
32, remove the power supply unit.
2) Open the top cover unit. Lifting up the
jam clearance cover, remove the 2
screws.
Top cover unit Jam clearance cover
Screws
Figure 3-7-7
3) Disconnect the connector, and then
remove the face-up deflector solenoid.
Connector
Face-up deflector solenoid
Figure 3-7-8
supply unit