B. Paddle Drive Solenoid
1) Following the staple tray unit removal
procedure described on Page 3-6,
remove the staple tray unit.
2) Unhook the 2 claws, and then remove
the connector cover.
Claws
Connector cover
Figure 3-7-2
3) Remove the screw, disconnect the con-
nector, and then take out the paddle
drive solenoid.
Screw
Connector
Paddle drive solenoid
Figure 3-7-3
C. Reference Plate Withdrawal Solenoid
1) Following the staple tray unit removal
procedure described on Page 3-6,
remove the staple tray unit.
2) Remove the 2 screws.
Screws
Figure 3-7-4
3) Disconnect the connector, remove the
cable clamp, and then take out the ref-
erence plate withdrawal solenoid.
Connector
Cable clamp
Reference plate withdrawal solenoid
Figure 3-7-5
CHAPTER 3
3 - 25