Advertisement
Assembly
Step 1
Assemble the handle (7) and its extension (5)
with the help of the screws (13) as depicted.
Step 2
Slide the parts (8) and then parts (2) and (3) on
one end of both axles (1). Now fix the wheels with
each one ring (10) and one cotter (11).
Step 3
Now, as depicted, fix the axle and spreading disc
under the grit hopper (4) with the help of the
screws (12).
Step 4
Now the handle assembled in step 1 is screwed
into the axle construction (12). Make sure that the
Bowden cable can be guided up between the
bars after assembly.
Step 5
The last step consists of fixing the driving unit to
the grit hopper with the help of the remaining cot-
ter (11). Mount the decorative caps (9) to the
wheels and fix the adjusting switch to the handle
bar.
Important Note: Reproduction and any commer-
cial use (of parts) of this operating manual re-
quires a written permission of WilTec Wildanger
Technik GmbH.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 50141
Page 4
09 2021-1
Advertisement
