Connecting Lead Wires - Generac Power Systems G0071020 Instruction Sheet

6. Inspect unit and verify if battery heater has already
been installed. If battery heater is not installed, pro-
ceed to next step. If battery heater has been
installed, proceed as follows:
a. Locate unused connector from previously
installed Y-harness.
b. Route unused connector through harness
grommet (D), and under engine to oil filter
heater.
c. Plug unused connector of Y-harness into oil fil-
ter heater connector.
d. Proceed to Completing
7. Plug connector into one of the Y-harness sockets
(C).
8. Pass lead wires and empty Y-harness socket (E)
beneath engine and through harness grommet (D)
in the engine divider panel. If empty Y-harness
socket will not be connected to a battery heater,
coil wires and secure with a plastic wire tie. Secure
all wires with plastic wire ties at least 0.5 in (1 cm)
away from fuel hoses.
9. Proceed to Connecting Lead

Connecting Lead Wires

2016 and Newer Units
Proceed as follows to connect lead wires:
1. See Figure 7. Pass lead wires through customer
connection panel grommet (A).
Figure 7. Lead Wires to Customer Connection
2. See Figure 8. Connect lead wires to the N1 and
N2 terminals as shown.
Oil Filter Heater Kit
Installation.
Wires.
A
002780
Figure 8. Input Sense Terminal Block
NOTE: It does not matter which lead wire goes into N1
or N2.
2013–2015 Units
See Figure 9. Connect lead wires to the N1 and N2 ter-
minals as shown.
Figure 9. Input Sense Terminal Block
NOTE: It does not matter which wire goes into N1 or N2.
N1
N2
T1
002781a
002887
3