Advertisement
Product Overview
1
1. Front weights (2 included)
2. Carrier (2)
Operation
Installing and Removing the
Weights
Always ensure that your machine has the appropriate number
of weights.
Refer to the following table for how many weights are
required on the front of the machine:
Attachment
Flex tooth rake
Nail drag
Nail drag with finish drag mat
1. Remove the 2 bolts and 2 nuts securing the existing
weights on the front of the machine (Figure 6).
Note: If the machine is equipped with the light kit,
remove the nut and the bolt securing the front light to
the machine. Retain all of the parts; refer to the Light
Kit Installation Instructions.
G023726
Figure 5
3. Chain with sleeve (2)
4. Drag mat
Number of weights required
4
6
8
2
3
4
2. Add or remove weights as necessary.
3. Secure the weights with the 2 bolts and the 2 nuts.
The Finish Drag Mat includes 2 longer bolts to
accommodate the additional weights that it requires.
Note: If the machine is equipped with the light kit,
install the front light by inserting the bolt through the
weights and securing it with the nut; refer to the Light
Kit Installation Instructions.
Stowing the Drag Mat
Whenever you are not using the drag mat, stow it in the
carriers.
To stow the drag mat, simply roll it up and place it in the
carriers.
Using the Drag Mat
Use caution while operating the machine with the drag mat
installed. Keep operating speeds to a minimum acceptable
level. For maximum mat life, avoid areas and objects that may
snag or interrupt the travel of the mat.
1. With the drag mat stowed in the carriers, drive the
machine to an area that requires grooming.
2. Remove the drag mat from the carriers, and place it
on the ground.
3. Pull the drag mat over the surface that requires
grooming.
4. When you have finished or are ready to groom a
different area, stow the drag mat in the carriers.
Cleaning the Drag Mat
Keep the drag mat clean. Excessive soil buildup increases the
attachment weight and may affect handling of the machine.
3
G024018
Figure 6
Advertisement
