XMOS xCORE-200 explorerKIT Hardware Manual page 4

xCORE-200 explorerKIT Hardware Manual
3 GPIO headers (J1 & J3)
J1 and J3 provide a rich set of IO that can be readily connected to off-board
components.
Figure 3:
GPIO
connectors
The xCORE ports are mapped to the GPIO connector pins as shown in Figure
Figure 5:
Notes:
XM007647C
1 - X0D31 is connected to the red terminal of the general purpose RGB LED (N).
This GPIO may be used for other purposes.
2 - X0D30 is connected to the green terminal of the general purpose RGB LED
(N). This GPIO may be used for other purposes.
3 - X0D29 is connected to the blue terminal of the general purpose RGB LED
(N). This GPIO may be used for other purposes.
4 - X0D28 is connected to the general purpose green LED (M). This GPIO may
be used for other purposes.
5 - X0D27 is connected to BUTTON B (SW2). This GPIO may be used for other
purposes, but care must be taken.
6 - X0D26 is connected to BUTTON A (SW1). This GPIO may be used for other
purposes, but care must be taken.
J3
4/18
J1
4 and